Flair

Acrylic Floor Finish and Sealer. Dynamic Chemical's FLAIR is a floor finish AND sealer which gives a beautiful clear acrylic surface to all types of floors. High solid content ensures maximum life and low maintenance cost. Dries to a glass clear finish. Simply mop on clean floor for an instant "wet look" finish like glass. Normally three coats gives a brilliant finish. Easily removed with "Strip". Suitable for most floor surfaces such as lino, cork, or as a protective coating to varnished wood.

SAFE 

  Provides a slip retardant surface to all floor areas. 
ECONOMICAL 

  FLAIR is long lasting and saves material, labour and money. The low level of 
  maintenance required can often cut costs by 50%. Provides a seal of protection 
  which allows scuffs, dust and other traffic stains to be removed by damp mopping 
  without destroying the shine. Regular care is minimised. 
EFFECTIVE 

  FLAIR does not yellow or powder and shines without buffing. Resists soiling, 
  scuffing and is slip-retardant. Is not harmed by detergent washing. Self levelling. 

 RECOMMENDED FOR 

  All types of floor surfaces including asphalt, asbestos, cement, composition, 
  linoleum, sealed cork, thermo plastic, terrazzo, vinyl and wood. 
DIRECTIONS 

  Surface should first be thoroughly cleaned with Dynamic Chemical’s STRIP 
  to ensure complete adhesion of FLAIR. Rinse thoroughly with water and allow 
  to dry. Apply FLAIR with a lamb’s wool applicator in one direction only 
  for each coat. Subsequent coats should be applied at right angles to the previous 
  coat once this has dried (usually 20-30 minutes is sufficient). Best results 
  with be obtained if FLAIR is spread as thinly as possible. 2 or 3 thin coats 
  will always give better results than 1 thick application. For regular maintenance 
  use Dynamic Chemical’s BIG BOY or FLOORPLUS which are both specially formulated 
  to be compatible with FLAIR.